Input Voltage Range: 6-28V DC
Max current sensing: 90A.
Voltage and current measurement configured for 5V ADC.
Switching regulator outputs 5.3V and 3A max.
IC: Atmega644 PA
GYRO/ACC.: 6050MPU InvenSense Inc.
INPUT VOLTAGE: 4.8V-6.0V.
AVR INTERFACE: Standard 6 Pin.
SIGNAL FROM RECEIVER: 1520us(5 channels).
SIGNAL TO ESC: 1520us.
ATmega328P with Arduino bootloader
MAX7456 monochrome on-screen display
FTDI cable compatible pinout
Standard 6 pin ISP header
2 independent power sections with an LED indicator on each
Solder jumpers for combining the power sections
Stackable design – perfect for integrating with OSDs and power distribution boards.
16 PWM I/O lines for ESCs, Servos and legacy receivers. 8 available on standard pin headers. 8 via side mounted connectors.
Full support for OneShot ESCs for easy PID tuning and a sharper response.
Supports SBus, SumH, SumD, Spektrum1024/2048, XBus, PPM, PWM receivers.
No external inverters required (built-in).
Dedicated output for programmable LEDs – great for orientation, racing and night flying.
Dedicated I2C port for connection of OLED display without needing flight battery.
Battery monitoring ports for voltage and current.
Sonar support for precision low-altitude hold.
Buzzer port for audible warnings and notifications.
Symmetrical design for a super tidy wiring.
Barometer mounted on the bottom of the board for easy wind isolation.
Wire up using pin headers, JST-SH sockets or solder pads. Use either right-angled or straight pin-headers.